Sign in to follow this  
sdc

2003 Land Cruiser Check Engine, VSC Trac, VSC Trac Off

Recommended Posts

sdc    0

I have a 2003 Land Cruiser which today brought on the check engine, VSC Trac and VSC Trac Off lights. I went to a local parts store to pull the codes: P0441 & P0446, evaporative emission control system incorrect purge flow (P0441); and evaporative control system vent control circuit fault (P0446). They asked if I topped off while filling up, which I can't say that I do (although I have in the past but not frequent enough to warrant this). They also suggested tightening the gas cap more thuroughly. It might be worth mentioning I just had all four rotors and pads replaced less than two weeks ago. I did read a few posts online about these three lights and low master cylinder brake fluid levels.

Any suggestions would be appreciated.

Share this post


Link to post
Share on other sites
 
Leighcm    3

It's the gas cap 90% of the time...just make sure you tighten it a couple clicks when you close it so the pressure is right.

Share this post


Link to post
Share on other sites
sdc    0

It's the gas cap 90% of the time...just make sure you tighten it a couple clicks when you close it so the pressure is right.

What about resetting the lights? Pull off the negative terminal for a couple of minutes to reset? Or what?

Share this post


Link to post
Share on other sites
Leighcm    3

It usually resets by itself once the pressure is back to the appropriate level, assuming that the gas cap is the issue.

Share this post


Link to post
Share on other sites
Sign in to follow this